Installing the outriggers


To carry two sets of speakers (one port and the other starboard), buy more about I’m installing pipes of 3/4-inch galvanized steel conduit onto the roof rack, by means of these custom-built brackets …

Standard conduit clamps grip the brackets to the big honkin’ roof rack and the pipes slip through these to be screwed down …

Before long, I’m going to put the many feet of speaker and light wire through these, install connectors at either end and get the whole rig wired up. The arrow here point to the clamps and brackets that hold the outriggers in place.


When I’m done with these, there will be much rejoicing. And, I hope, very, very little need for improvement on the immediate design.

Lots still to do …

Leave a Reply

You must be logged in to post a comment.